A special aluminum friction fastener used in conjunction with plank grating and embedded grating frames. When plank is banded, clips are installed by the manufacturer.

A special friction fastener available in aluminum, stainless steel and galvanized steel used in conjuction with bar grating and embedded grating frames. (Note: Cross bars may need to be snipped in the field to facilitate placement of grating clamps.)

A special bent-clip type fastener for removable bar grating panels, available in aluminum, stainless steel and galvanized steel. Clips only are supplied by the grating manufacturer. Other fastening accessories to be provided by others. (Note: Cross bars may need to be snipped in the field to facilitate placement of saddle clips...Clips usually do not bottom out.)

(To be welded between bars)

Anchor Blocks of 1/4" or 3/16" thick aluminum may be shop welded by the grating manufacturer and used to fasten permanent or removable grating panels. Anchor blocks are recessed thus offering a trip-free surface.

For close-mesh aluminum grating (7/16" bearing bar centers), a countersunk land may be drilled by the grating manufacturer for use with a 1/4" diameter TEK screw (by others.)

The most versatile clip anchor available is the Z Clip. These clips are especially helpful in holding down riveted grating. Z Clips are manufactured from stainless steel and are available in 1" (1" and 1-1/4" grating), 1-1/2" (1-1/2" and 1-3/4" grating), 2" (2", 2-1/4" and 2-1/2" grating) with a pre-punched hole to accept a 1/4" bolt or TEK screw (sold seperate).